All guidesCostsUpdated November 2026 · Updated November 2026

How much to chargefor pressure washingin 2026.

Most pressure washing jobs in Canada land between $150 and $600, and most pros charge $0.15 to $0.75 per square foot depending on the surface. Here is how to set your rates from your real costs, so the price holds up when the job takes longer than the estimate.

How much to charge for pressure washing comes down to a $150 to $300 minimum, then $0.15 to $0.75 per square foot depending on the surface, with a house wash at $250 to $350 for a single storey and $350 to $550 for two storeys, per HomeStars’ 2026 price guide, updated August 21, 2026. The range is wide because the surface matters more than the size: concrete is fast, wood is slow, and a house wash is a different job from a driveway.

Undercharging is the usual mistake. A driveway that takes two hours including driving, setup and cleanup has to pay for all of it, not just the twenty minutes the wand is running. The method below builds your price from your costs, so you know your floor before you look at what anyone else charges.

What does pressure washing cost in 2026?

HomeStars’ 2026 price guide puts the average pressure washing job in Canada at $150 to $600 or more, with per-square-foot rates of $0.15 to $0.75 and hourly rates of $100 to $200. Toronto operators listed in 2026 guides charge $250 to $600 per appointment, with most homeowners spending around $450. A Victoria operator’s published 2026 rates start at a $225 minimum, then $0.35 to $0.55 per square foot, and about $800 to $900 to wash every hard surface on a typical home.

Those are customer prices, not your rates. Your price has to cover your costs in your city, at your speed, with your equipment. Use the published ranges as a sanity check, then build your own numbers with the method below.

Rates by surface

Price each surface for what it actually takes. The table uses HomeStars’ 2026 guide and published 2026 operator rates in Toronto, Vancouver and Calgary.

SurfaceTypical chargeNotes
Driveway, concrete$100 to $260About $0.25 to $0.35 per sq ft; a two-car driveway runs $150 to $375 by city
House wash, one storey$250 to $350Soft wash, not high pressure, on siding
House wash, two storeys$350 to $550Up to $700 to $1,000 for large or three-storey homes
Deck, wood$150 to $350About $0.30 to $0.55 per sq ft; lower pressure, slower work
Patio and walkways$150 to $400About $0.20 to $0.40 per sq ft
Fence$150 to $300Both faces where you can reach them
Concrete, flat$0.08 to $0.20 per sq ftLarge commercial areas; residential is usually higher
Commercial$0.40 to $0.50 per sq ftLarger areas, specialist equipment, off-hours work

Interlock is the surface to price carefully. A plain wash runs about $0.25 to $0.50 per square foot, but a wash with new polymeric sand and weed treatment runs $0.75 to $1.25, and stain treatment with sealer runs $1.25 to $1.75. Quote the sand and sealer as separate lines, because the customer who only wanted a wash will not thank you for a $1.25 rate, and the one who wanted it sealed will not thank you for sand in the joints and no sealer.

Price from your costs, not the market

Start with what a job actually costs you, then add overhead and profit. That number is your floor. The market tells you whether the floor is competitive, not what the price should be.

1
Labour at your loaded rate.

Your hourly wage plus vacation pay, CPP and EI, workers’ comp and benefits, usually 20% to 35% on top of the wage. A $30 an hour worker costs about $38 an hour loaded. Count driving, setup, cleanup and the walkthrough, not just wand time.

2
Consumables and fuel.

Chemicals, soap, water, fuel for the machine and the truck, wear on hoses, nozzles and the surface cleaner. Track it per job for a month and you will have a real number.

3
Equipment and overhead.

The machine, trailer, insurance, phone, software and marketing, spread across your billable hours. Our hourly rate calculator does this properly.

4
Add profit on purpose.

Profit is a line you plan for, not what is left over. Many operators aim for a 10% to 20% net margin after overhead. Our markup calculator shows markup and margin side by side, because they are not the same number.

Once you know your cost per hour, the per-square-foot rate follows. If your loaded cost is $75 an hour and you wash 500 square feet of concrete an hour, your floor is $0.15 a square foot before profit. Charge $0.30 and you have room for the slow jobs, the callbacks and the rainy days. Charge $0.15 because that is what the other guy charges, and you are working for free on the days the driveway is stained.

Set a minimum charge

Every visit has fixed costs: driving there, unloading, setting up, packing up and driving back. A $60 job that takes ninety minutes door to door loses money even if the wand was only running for twenty minutes.

Most Canadian operators set a $150 to $300 minimum, and Toronto operators commonly start at $200 to $300. Pick a minimum that covers one hour of loaded labour plus travel, and say it on the phone before you drive out. Customers respect a minimum when it is stated up front. They resent it when it appears on the invoice.

Try this line

“Our minimum is $200, which covers the visit, setup and the first hour. A driveway this size usually comes in around $250 to $300. I can confirm the exact price when I see it.”

Flat, per square foot or hourly?

Each method fits a different job. Use the right one and the customer understands the price before you start.

  • Per square foot. Best for big flat surfaces: driveways, patios, walkways and commercial concrete. Measure it, multiply, and the customer can check your math. Watch out for small areas, where the rate has to be higher because setup time dominates.
  • Flat per surface. Best for house washes, decks and fences, where the work is about the surface and its condition, not just its size. A two-storey house wash is a flat price, not a square-foot calculation.
  • Hourly. Best for messy, unpredictable work: heavy moss, years of buildup, stain removal and commercial jobs where you cannot see the whole scope until you start. Quote an hourly rate with an estimate of hours, and a cap so the customer is not exposed.
  • Whole-property packages. Best for upselling. One price for the driveway, walkways, patio and house wash together, with a small discount against the separate prices. It fills the day and the customer feels they got a deal.

Whatever method you use, put it in writing with the surfaces named and the price fixed before you start. A quote that says “pressure wash house and driveway: $450” is a dispute waiting to happen. One that says “two-storey house soft wash, two-car driveway, front walkway: $450” is a job.

Add-ons that lift the ticket

The cheapest new revenue is work you are already on site for. Offer it while you are there, not in a follow-up email a week later.

  • Gutter cleaning. You are already on a ladder for the house wash. Price it by the linear foot or as a flat add-on.
  • Roof soft wash. About $450 to $700 for a typical home, per 2026 pricing guides. Low pressure only, and only if you are trained for it.
  • Sealing. Driveways, interlock and decks after washing. Charge for the sealer and the return visit separately, so the customer sees what they are paying for.
  • Window cleaning. Ground-level windows are a natural add-on at about $7 a window, per published Toronto operator rates.
  • Recurring washes. A spring and fall wash on a maintenance plan turns one customer into two jobs a year. Offer the second visit at booking, while the first job is still fresh.

Contruva’s quoting makes this easy: build the base price on site, add the extras as options, and send it before you leave the driveway. Customers pick the middle option more often than you would expect.

A worked example

A two-car concrete driveway, about 500 square feet, with oil stains near the garage and moss along the edges. Here is how the price is built.

LineAmount
Labour: 1.5 hours at $38 loaded$57
Chemicals, fuel and wear$18
Overhead share (insurance, truck, software)$22
Cost subtotal$97
Profit at 20% margin (cost ÷ 0.80)$121
Stain pre-treatment$35
Quoted price, before tax$156

That lands at the low end of the $150 to $375 range published for a two-car driveway, which tells you two things: the job is priced fairly, and the minimum charge is doing its work. A 300-square-foot driveway at the same rate would cost less to do, but the minimum keeps it at $150 to $200, because the visit costs the same. If the customer is registered for GST or HST, charge it on the full price. If you are registered, you charge HST on the whole job, materials and labour included. Our HST on materials guide explains how that works.

Quoting it so customers say yes

Speed wins first. The customer asked three operators for a price, and the one whose quote shows up first, is easiest to understand, and is easiest to say yes to usually gets the job. Aim to send it within 24 hours of the visit, while the conversation is still fresh.

Make the quote specific: the surfaces, the method, the price, the deposit and the expiry. A 15- or 30-day expiry protects you while material and fuel prices move, and gently encourages a decision. Give them a way to approve and pay the deposit from their phone, without printing, signing and scanning anything. Then follow up once if they have not replied in three days, with something useful, like the next open slot. Our guide to starting a pressure washing business covers the setup side, and the pressure washing software page shows how Contruva runs the scheduling, quoting and follow-ups for a washing crew. If you want the numbers behind your rate, start with the free estimate generator and the hourly rate calculator.

01Questions

Straight answers.

Still unsure? Call us at +1 (647) 922-5436. A real person picks up.

Ask us anything

How much should I charge per square foot for pressure washing?

Most Canadian operators charge $0.15 to $0.75 per square foot, per HomeStars’ 2026 guide. Concrete runs about $0.15 to $0.30, decks $0.30 to $0.55, and interlock with new sand and sealer up to $1.75. Small jobs need a higher rate because setup time dominates.

How much does it cost to pressure wash a driveway?

A driveway typically costs $100 to $260, per HomeStars’ 2026 guide, and $150 to $375 for a two-car driveway in published 2026 Toronto, Vancouver and Calgary rates. The price depends on size, surface and stains.

How much does it cost to pressure wash a house?

A single-storey house wash typically runs $250 to $350, and a two-storey home $350 to $550, per HomeStars’ 2026 guide. Large or three-storey homes can run $700 to $1,000 or more.

What is a good minimum charge for pressure washing?

Most Canadian operators set a $150 to $300 minimum, and Toronto operators commonly start at $200 to $300. The minimum should cover one hour of loaded labour plus travel, and be stated on the phone before you drive out.

Should I charge by the hour or by the square foot?

Charge flat surfaces like driveways and patios by the square foot, house washes and decks as a flat price, and messy or unpredictable work by the hour with a cap. The method should match the job, and the price should be fixed in writing before you start.

Do I charge HST on pressure washing?

Yes, if you are registered for GST/HST. You charge it on the full price of the job, and you claim back the HST you paid on chemicals and fuel as an input tax credit. This is general information, not tax advice, so check the specifics with your accountant or the CRA.

Quotes they sign.

Build it on site, get the deposit on approval.

Start free trial